DCK Series Stroke Controller

The Stroke actuator will change the location of adjustable screw by the input conrol signal to change the length of stroke of the dosing pump,and adjust the dosing pump capacity automatically.

Specification

*Input power(standard):220V+/-10%,1 phase,50/60Hz'

*Adjust speed:16s/round

*Power:20VA

*IP65

*Relative humity:90%(25°C)

*Input control signal(standard):4~20mA(120ohm inputimpedance)

*Output feedback signal:4~20mA(120 ohm inputimpedance)

*EMC(Electric Magnetic Compatibility) of Signal cable:following EN50081-1&EN50082-2

Wiring

*Power cable:three codes

*Signal cable:red is "-",yellow is collective cable(To avoid short circuit,connection the singal cable first)

Operation

Put the buttons"AUTO" or "MANUA" to choose the control automatic or manual mode.The electric actuator will change the length of stroke automatically follwing the signal at 4~20mA if press the "AUTO".Users can press the button inputimpedance inputimpedance ▲ UP to increase the length of stroke or the button ▼ DOWN to decrease the stroke of length.The stroke length will display at percentage.