Itis composed of cooling water supply,pipeline and large condenser.Based on the principle of watervapor exchange,a gas-liquid exchange mode is formed between hot steam vapor hydrate and liquid afterit enters the central vacuum condenser through the main pipe.At the same time,through multiple parti-ased on the principle of watervapor exchange,a gas-liquid exchange mode is formed between hot steam vapor hydrate and liquid afterit enters the central vacuum condenser through the main pip
tions and layout optimization,the gas temperature can be reduced to below 40 degrees Celsius after ex-change in accordance with the setting mode,so as to achieve efficient condensation

lts cooling water supply system has two groups of control,and the corresponding level switch controls itsnormal stärt and stop action.At the same time,the temperature detection device on the equipment can orrectly determine the actual gas supply temperature,so as to adjust the water to achieve the goal of
energy saving.

Collect the water vapor mixture from the vacuum pump through the large-diameter pipe to  reduce the back pressure caused by poor drainage.At the same
time,the water is discharged by a large diameter pump in a vacuum environment.

The over-capacity vacuum buffer tank can realize the stability and reliability of the vacuum system,avoid the phenomenon  of  high  and  low  due  to  the  sudden
change in the number of equipment.At the same time,the large vacuum energy storage can make up for the pressure drop caused by the momentary supply short- age  of the  vacuum  pump  when  the  molding  equipment is used

Equipment running state,with a variety of fault alarm  and operation  protection functions.And  reserve com- puter centralized management interface.