Micro Duct End Cap Brief Introduction: To keep Micro Duct networks free of debris, seal the system with Push Fit End Caps. With the same functionality as the Push-Fit Connectors, installation simply involves pushing the Micro Duct into the End Cap. The End Cap can be attached and removed 10 times while still maintaining the same high performance characteristics. Push-Fit Micro Duct End Stop Connector operate at 15 BAR (218 psi) with a maximum permissible leakage rate of 1cc/min. This is equivalent to 1 bubble every 3 seconds. Higher pressures have been used in the field with no increase in leakage rate. Quick Burst rating is 25 BARS (363 psi). Product Picture: Specification:
Model No.
Part Name
Blow Pressure
Pull Strength For HDPE tube
Pull Strength For LSZH tube
Life time
FMC-E-03
3 mm DI end stop
>18bar
≥350N
>150N
10 Years
FMC-E-04
4 mm DI end stop
>18bar
≥350N
>150N
10 Years
FMC-E-05
5 mm DI end stop
>18bar
≥350N
>150N
10 Years
FMC-E-06
6 mm DI end stop
>18bar
≥350N
>150N
10 Years
FMC-E-07
7 mm DI end stop
>18bar
≥350N
>150N
10 Years
FMC-E-08
8 mm DI end stop
>18bar
≥350N
>150N
10 Years
FMC-E-10
10 mm DI end stop
>18bar
≥350N
>150N
10 Years
FMC-E-12
12 mm DI end stop
>18bar
≥350N
>150N
10 Years
FMC-E-14
14 mm DI end stop
>18bar
≥350N
>150N
10 Years
FMC-E-16
16 mm DI end stop
>18bar
≥350N
>150N
10 Years
Design Lifetime The connector shall meet all performance requirements over a minimum period of 10 years at the normal condition.
Supplier Information
Shanghai Weibo Erguang Communication Equipment Co., Ltd.